![]() ![]() Merge Regions and Pads Inside FFootprintĮnable this option to merge regions and pads within a footprint during the generation of Gerber outputs. Edit Layer Class - click to edit the name of a Layer Class.Ĭheck this box to allow unconnected pads in the mid-layer on Gerber plots.Add Layer Class - click to open the Layer Class Name dialog then enter a name for the new layer.The following are additional commands included on the right-click menu: The Plot Layers and Mirror Layers commands also can be accessed by right-clicking the layer name in the list region. Used On - select to check all boxes in the Mirror column of the layers that are used in the design.All Off - select to clear all checked boxes in the Mirror column (no mirrored Gerber data will be created).All On - select to check all boxes in the Mirror column (mirrored Gerber data will be created for all checked layers).Use the drop-down to access a menu of commands that allow the Mirror field for all layers in the Layers to Plot region to be enabled or disabled: Used On - select to check all boxes in the Plot column of the listed layers that are used in the design.All Off - select to clear all checked boxes in the Plot column (no Gerber data will be created). ![]() All On - select to check all boxes in the Plot column (Gerber data will be created for all checked layers).Use the drop-down to access a menu of commands that allow the Plot field for all layers in the Layers to Plot region to be enabled or disabled: Mirror - check the Mirror box to the right of each layer if you want a mirrored Gerber file to be created.Ĭheck the box next to each mechanical layer(s) you want added to all plots.Plot - check the Plot box next to each specific layer(s) you want to plot as part of the generated output.This region is a list of layers that can be plotted as part of Gerber generation. The Layers tab of the Gerber Setup dialog Layers To Plot The 2:4 and 2:5 formats only need to be chosen if there are holes on a grid finer than 1 mil. If you are using one of the higher resolutions, check that the PCB manufacturer supports that format. Each Gerber file corresponds to one layer in the physical board – the component overlay, top signal layer, bottom signal layer, the solder masking layers, etc. It is advisable to consult with your board fabricator to confirm their requirements before supplying the output documentation required to fabricate your design. This dialog provides tools to completely configure your Gerber file output options. Automatically Opening the Generated Output.Merge Regions and Pads Inside FFootprint.Mechanical Layer(s) to Add to All Plots. ![]()
0 Comments
Leave a Reply. |